What are the faults and treatment methods in the blowing mold process?

Faults and treatment methods in the process of blowing mold

1. The action is not in place
Solution: Check if something is stuck. Adjust the gas flow valve.

2. High temperature alarm for light box water channel.
Solution: Disassemble the rubber tube connected to the water channel, and use low-pressure air and alcohol to purge and clean the water channel.

3. Exhaust sound is too loud
Solution: Check whether the high-pressure exhaust muffler is damaged or falling off.

4. The action is stuck.
Solution: restart the machine.

5. Uneven hypoblast of embryonic duct
Solution: Adjust the position of the embryo bucket.

6. Cannot manually origin
Solution: Check whether the shifting of the first gripper, the shifting of the second gripper and the variable pitch positioning plate is stuck to the corresponding position, if not, manually make them stuck to the corresponding position, and then the origin.

7. Gripper failure
Solution: Adjust the height of the sliding table or the position of the gripper.

The above are the faults and treatment methods in the blowing mold process.

/